Soffit & Fascia in
Stony Plain, Alberta.
Aluminum soffit and fascia with the intake ventilation actually calculated and the eave opened up. On Stony Plain's older housing and its very tight new builds, this is the fix for winter attic moisture.
Free Soffit & Fascia Estimate
Get your Stony Plain quote.
Free, no obligation, and priced on your actual Stony Plain home. We reply the same day.
We come out to your Stony Plain address, take a proper look at what you actually have, and put a real number in writing. No obligation, no sales pitch, and we get back to you the same day.
Or call (780) 937-1184Soffit & Fascia in Stony Plain
What Stony Plain actually needs from a soffit & fascia job.
Stony Plain gives us both versions of the same problem. In the older core and Forest Green, houses that have had insulation topped up repeatedly since the 1970s now have blow-in packed against the underside of the deck at the eave, sealing the intake vents shut from inside while the soffit looks perfect from the street. In the newer communities like Westerra and SouthCreek, the more common finding is perforated soffit installed over solid sheathing that was never cut open behind it, which ventilates nothing at all.
Either way the outcome is the same, and it is worse here than most places because of the cold. At minus 30 or minus 40, a roof deck is dramatically colder than the air in the house below it, and every gram of household moisture that reaches the attic freezes on it. Weeks of that accumulate, and then a thaw arrives and it all melts at once. That is the February ceiling stain, and it is not a leak.
Alberta code asks for at least 1/300 of the insulated ceiling area in net free vent area, split roughly evenly between soffit intake and exhaust near the ridge. We calculate that against your actual ceiling area rather than counting panels, install rafter baffles so future insulation top-ups cannot re-block the eave, and replace fascia board that has softened rather than capping over it.
About Stony Plain
Stony Plain was incorporated as a village in 1907 and a town the following year, and the core still reads that way: more than forty painted heritage murals around downtown, the Multicultural Heritage Centre in the old brick school, and genuinely old housing stock beside it. Around that core sit some of the region's nicest newer communities, Genesis on the Lakes built around a seven-acre lake and Graybriar wrapped around the golf course. It is also the most weather-exposed town we work in, sitting further west with roughly 536 millimetres of annual precipitation and recorded extremes from minus 40 to plus 35.7.
Where We Work
Stony Plain neighbourhoods we work in.
We have done soffit & fascia work across Stony Plain, from the established streets in Downtown Stony Plain, Forest Green, Brickyard to the newer builds in Westerra, Silverstone, SouthCreek.
Our Standard
What every Stony Plain soffit & fascia job includes.
Soffit and fascia get treated as trim, and they are actually the intake half of your attic ventilation system. Every cubic foot of air that leaves at the ridge has to enter somewhere, and it enters through the soffit. Get that wrong and the attic stops breathing, which is how you end up with attic rain in February and shingles that age from underneath. We install pre-finished aluminum with the vented area properly proportioned, and we open the blocking behind it so the airflow is real rather than decorative.
Vented soffit sized to the code
Alberta requires at least 1/300 of insulated ceiling area in net free vent area, split roughly half intake and half exhaust. We calculate the intake rather than guessing at panel count.
Blocking opened behind the panels
Perforated soffit installed over solid sheathing that was never cut open ventilates nothing. We check, and we open it.
Pre-finished aluminum
Baked enamel finish that holds colour, will not rot, and does not need painting. Colour matched to your fascia, eavestrough and trim.
Fascia over sound wood
Aluminum fascia capping is only as good as the board behind it. Rotten fascia gets replaced, not wrapped over, because wrapping rot just hides it.
Tight mitred corners
Corners cut and folded properly rather than butted and caulked. It is the detail that separates a finished eave from a patched one.
Baffles at the eave
Rafter baffles so blow-in insulation cannot drift into the eave and seal the intake shut, which is the single most common ventilation failure we find.
Bird and pest exclusion
Gaps at the eave closed properly so squirrels, birds and wasps are not using your soffit as a front door.
Done with the eavestrough
Fascia, soffit and eavestrough share the same access. Doing them together typically costs 10 to 15 percent less than separate visits.
Stony Plain Pricing
What this costs in Stony Plain.
Real 2026 ranges for the Edmonton region. Your written quote gives you a firm number after we have been on site, because a price without an inspection is a guess.
Aluminum soffit and fascia
$12 – $25 / linear ft
Installed, both items, pre-finished aluminum
Single-storey home
$2,200 – $5,500
Roughly 120 linear feet of each
Rafter baffles / intake correction
$400 – $1,200
Clearing blocked soffit intake, per attic
Attic ventilation upgrade
$300 – $800
Added or corrected exhaust venting
Doing soffit and fascia together costs meaningfully less than doing them separately, because the access equipment and setup are shared. Rotten fascia board discovered during removal is replaced at cost and shown to you first. For the complete regional breakdown, see our Edmonton roof replacement cost guide.
Permits · Town of Stony Plain
Do you need a permit in Stony Plain?
Stony Plain follows the regional norm: replacing a roof covering or exterior finish with similar material is maintenance and does not require a building permit, while structural alterations, changes to roof shape or height, added floor area, and repairs following fire or flood do. Heritage-area properties in the older core can carry additional considerations, and we check before we start.
FAQ
Stony Plain soffit & fascia questions.
Mostly because of how cold it gets. Stony Plain has recorded lows to minus 40, and the colder the roof deck the more aggressively household moisture freezes onto it. Frost accumulates through the cold stretch, then a thaw melts the whole lot at once. The moisture is the same as anywhere. The deep cold just gives it more time and more surface to collect on before it releases.
Installed pre-finished aluminum soffit and fascia together runs roughly $12 to $25 per linear foot, so a typical single-storey home with about 120 linear feet of each lands at $2,200 to $5,500. Clearing blocked intake and fitting baffles is $400 to $1,200 on its own, and a ventilation upgrade $300 to $800. Doing soffit, fascia and eavestrough in one visit saves 10 to 15 percent.
That is the classic attic rain presentation and it is very common here. Before anyone quotes you a roof, get someone into the attic to check whether the soffit intake is clear and whether the bathroom fans actually vent outside. On Stony Plain homes the answer is usually blocked or absent intake, and the fix costs a fraction of a re-roof that would not have solved it anyway.
Sometimes, if the soffit is sound aluminum with adequate vented area. But fascia usually rots because water has been getting behind it for years, and that same water has often been in the soffit cavity. We would rather open it, look, and tell you honestly than cap over a problem.
From the ground you cannot, which is the problem. The panels look perfect while blow-in insulation has drifted into the eave and sealed the intake from inside. It takes someone in the attic with a light checking whether daylight and airflow reach the eave. That is the first thing we look at, and it is free.
It is the most common cause we find. Blocked intake stops the attic flushing moist air, so the moisture your household produces condenses as frost on the cold roof deck through a cold snap and melts through your ceiling when it warms up. Clearing the intake and adding baffles fixes more attic moisture problems than anything else we do.
More in Stony Plain
Everything under one roof.
Roofing in Stony Plain
Century-old houses in the downtown core, 1970s bungalows in Forest Green and Brickyard, and new two-storeys in Westerra and Genesis on the Lakes.
Roof Repair in Stony Plain
Wind damage, ice at the eaves, and leaks in older buildings where the water is rarely where the stain is.
Siding in Stony Plain
Old cladding on genuinely old houses, and new builds on lots with nothing between them and the prairie wind.
Eavestrough in Stony Plain
Seamless aluminum formed on site, sized for genuinely heavy precipitation, and pitched so nothing stands and freezes.
Worth Reading
