Siding in
Fort Saskatchewan, Alberta.
Sixties and seventies cladding at the end of its life, nineties vinyl gone brittle, and new builds where the flashing details decide whether the wall stays dry. We re-side across Fort Saskatchewan.
Free Siding Estimate
Get your Fort Saskatchewan quote.
Free, no obligation, and priced on your actual Fort Saskatchewan home. We reply the same day.
We come out to your Fort Saskatchewan address, take a proper look at what you actually have, and put a real number in writing. No obligation, no sales pitch, and we get back to you the same day.
Or call (780) 937-1184Siding in Fort Saskatchewan
What Fort Saskatchewan actually needs from a siding job.
The older Fort Saskatchewan neighbourhoods carry cladding that has been on the wall a long time. In Sherridon, Pineview, Clover Park and Bridgeview we routinely take off original wood, hardboard and early aluminium from the 1960s and 70s industrial boom. Those wall assemblies were built before drainage planes and rainscreen gaps were normal practice, so what is behind the cladding is usually more interesting than what is on it.
The detail we look for first is kick-out flashing at roof-to-wall junctions. It was not standard practice when these houses were built, and without it every rainfall on that roof section has been aimed straight into the wall assembly at a point invisible from outside. On homes with an attached garage or a bonus room, which is most of the newer half of the city and plenty of the older half, that is exactly where the rot is. Finding it is the reason to tear off rather than side over.
For material, we recommend LP SmartSide to most Fort Saskatchewan homeowners. Vinyl loses impact tolerance below about minus 20, and this city gets genuinely cold, so a wall taking wind-driven ice in February is where vinyl cracks. Engineered wood keeps its toughness in the cold, comes in 16-foot lengths that reduce seams across long walls, and can be repaired and repainted rather than needing a colour-matched panel that may be discontinued in a decade. James Hardie is the right call where the budget and the elevation justify it.
About Fort Saskatchewan
Fort Saskatchewan began as a North-West Mounted Police post in 1875 and became a city in 1967, right as the petrochemical build-out along the North Saskatchewan took off. It now anchors Alberta's Industrial Heartland, the largest industrial area in Canada west of Toronto, with Dow, Sherritt, Nutrien, Linde and Shell all within reach. For a roofing company that means a compact, walkable set of older neighbourhoods around the river valley, a large cohort of homes built in the 1960s and 70s industrial boom, and a wide belt of new construction pushing south.
Where We Work
Fort Saskatchewan neighbourhoods we work in.
We have done siding work across Fort Saskatchewan, from the established streets in Downtown, Sherridon, Pineview to the newer builds in Southfort Estates, Southfort Meadows, Southfort Ridge.
Our Standard
What every Fort Saskatchewan siding job includes.
Siding is the part of the exterior people judge from the street and the part that quietly decides whether your walls stay dry. We install vinyl, LP SmartSide engineered wood and James Hardie fibre cement, and we build what goes behind them properly: a correctly lapped water-resistive barrier, head flashing over every opening, sill pans below, and kick-out flashing wherever a roof edge meets a wall. That last piece of metal is small, cheap and the most commonly omitted detail in residential construction.
Full tear-off and inspection
Old cladding comes off so we can see the sheathing. Rot found behind siding is common and it is always cheaper to deal with while the wall is open.
Proper water-resistive barrier
House wrap lapped shingle-style so water runs down and out rather than into the laps, taped at seams and penetrations.
Flashing done right
Head flashing above every window and door, sill pans below, and kick-out flashing where roof meets wall. Skipping the kick-out is how walls rot invisibly for years.
Vinyl siding
Hung correctly with fasteners centred and left slightly loose so the panels can move through a 60-degree annual temperature swing without buckling or pulling.
LP SmartSide engineered wood
Our most-recommended option here. Real wood texture, far better cold-weather impact resistance than vinyl, long 16-foot lengths, repairable and repaintable.
James Hardie fibre cement
The premium choice. Dimensionally stable, non-combustible, excellent impact resistance, and factory ColorPlus finish that holds colour for decades.
Trim, corners and details
Tight mitres, proper corner posts, and clean transitions at stone, soffit and roofline. This is where a siding job either looks finished or does not.
Clearances that matter
Siding held off grade, off roof decks and off horizontal surfaces so it is not wicking water at the bottom edge.
Fort Saskatchewan Pricing
What this costs in Fort Saskatchewan.
Real 2026 ranges for the Edmonton region. Your written quote gives you a firm number after we have been on site, because a price without an inspection is a guess.
Vinyl
$5 – $10 / sq ft
Typical full re-side $12,000 – $22,000
LP SmartSide
$9 – $15 / sq ft
Typical full re-side $20,000 – $34,000
James Hardie
$10 – $18 / sq ft
Typical full re-side $24,000 – $45,000
Cedar
$15 – $25 / sq ft
Beautiful, and the highest maintenance option here
Ranges assume roughly 2,000 to 3,000 square feet of wall area and include tear-off, house wrap, trim and flashing. Storeys and scaffolding, window and door count, gables and dormers, and any rot found behind the old cladding all move the number. For the complete regional breakdown, see our Edmonton roof replacement cost guide.
Permits · City of Fort Saskatchewan
Do you need a permit in Fort Saskatchewan?
Fort Saskatchewan treats replacing a roof covering or exterior finish with similar material as maintenance, so no building permit is required. A permit applies where the work alters the structure, changes roof shape or height, adds floor area, or repairs fire or flood damage. We confirm the requirement for your address before we start and handle the application when one is needed.
FAQ
Fort Saskatchewan siding questions.
For a home with roughly 2,000 to 3,000 square feet of wall area, vinyl runs about $12,000 to $22,000, LP SmartSide $20,000 to $34,000, and James Hardie $24,000 to $45,000, including tear-off, house wrap, trim and flashing. The compact single-storey homes in the older neighbourhoods often come in at the lower end because there is less wall area and less scaffolding.
Expect some, and it is better to find it than to cover it. On homes of that vintage we most often see localised rot below windows and at roof-to-wall junctions where kick-out flashing was never installed, rather than wholesale failure. We photograph everything, show you before we cut, and price repairs transparently. Siding over the top is the only way to guarantee you never find out.
It is a reasonable budget choice provided it is hung correctly, with fasteners centred in the slots and left slightly loose so panels can move through a 60-degree annual swing. What we would push back on is vinyl on a heavily exposed elevation in a city that regularly sees minus 30, because that is where it goes brittle and cracks. If there is room in the budget, LP SmartSide is the better answer for this climate.
For most homes here, LP SmartSide. Vinyl gets brittle below about minus 20 and cracks from impacts it would shrug off in summer, while engineered wood keeps its impact resistance in the cold, looks like real wood, and is repairable. James Hardie is the premium answer if you are staying long-term or the elevation takes hard weather.
We do not recommend it. Going over the old siding means nobody ever sees the sheathing or the water barrier behind it, and hidden rot is common, particularly below windows and wherever a kick-out flashing was omitted. Tear-off costs more up front and is the only way to know what you are building on.
Replacing exterior finish with similar material is generally treated as maintenance across the Edmonton region and does not require a building permit. Changing the exterior in a way that affects the structure, or work on a property with architectural controls, can be different. We confirm the requirement for your address before we start.
More in Fort Saskatchewan
Everything under one roof.
Roofing in Fort Saskatchewan
The 1960s and 70s homes around Sherridon, Pineview and Clover Park are on their third roof, and Southfort and Westpark are filling in fast.
Roof Repair in Fort Saskatchewan
Leaks, hail from a heavy 2026 storm season, wind damage on the river-valley edges, and winter ceiling stains that turn out not to be leaks at all.
Eavestrough in Fort Saskatchewan
Seamless aluminum formed at your Fort Saskatchewan address, sized for the roof feeding it, and pitched so nothing stands and freezes.
Soffit & Fascia in Fort Saskatchewan
Aluminum soffit and fascia with the attic intake actually calculated and the eave opened up behind the panels.
